Defectoscopes
- Details
-
Published on Friday, 05 February 2010 21:35
-
Written by Sasa
-
Hits: 1943
You need only one set of equipment for the full automated ultrasonic testing of tubes!Ultrasonic tester UZT-K170 is intended for full automated ultrasonic testing of seamless steel tubes including ending areas. Ultrasonic tester UZT-K170 can detect longitudinal and transverse flaws, laminations as well as dimensional wall thickness changes of tubes.
Ultrasonic tester controls tubes by using translational-rotary movement. Immersion and slot-hole methods are transmission methods of ultrasonic oscillations. Specialized equipment of ultrasonic tester can execute non-destructive testing not only of basic part of tube but also testing of ending areas of tubes. 100% ultrasonic testing of whole tube in single pass including ending areas at the beginning and at the end.
- Automated ultrasonic testing of tubes including ending areas
- Tubes sorting by flaw types and wall thickness tolerances
- Mark of flaws by paint
- Testing report saving, database of tested products for possibility of next analysis and export
- Interface for factory automation network
|  |
Technical parameters:
Tested tubes:
seamless steel tubes;
diameter 60 – 169 mm; up to 450 mm*;
wall thickness 3 – 25 mm*;
length min 6 м; 4 м*
Tube movement: translational-rotary
Testing frequency: 4 МHz
Number of used testing channels (transducer quantity): 32 + 5
Contact liquid: water
Tested flaws: longitudinal and transverse flaws, laminations, dimensional wall thickness changes +/-
Conditioned sensitivity to flaw detection: meet demands of API, ASTM, ASME, DIN standards
* - other dimensions of tested tubes is possible in coordination with customer
